In this article we’re going to examine how to create your own dog mask. We’ll cover the basics and then go on to take a look at some of the more advanced tips and techniques that you can use.
If you have a dog that likes to bark, and especially if your dog loves to play in the backyard and other regions of the house, you need to get them some particular dog protection.
Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the setup that will look a little scary at first, but it’s actually quite straightforward. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can not simply cut a rectangular shape from the cardboard, so you will need to cut around the edge of the mask so that you get something that resembles a cone. The most important thing here is to be realistic with what type of paper plate which you’re using.
Then you will have to wrap the cardboard around the edges of the paper plate, making certain that there is a good seal between the two pieces so that you can make certain that nothing will leak when you put the mask on. Be sure that the edges are cut so that the edges aren’t sharp, as this can damage the edges of the mask.
Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making sure that it runs smoothly and evenly across the whole mask. You will want to start with one side of the mask , so that you can work your way round it before moving onto the other side. The paint has to be slightly thicker than the cardboard, and it’s best that you leave about one-third https://schpl-schibsted-pl-frontend-qa.seals.schibsted.pl/?p=20417 of an inch of paint on the edges so that it runs over the cardboard.
Don’t worry too much about the paint getting stuck to your mask. It’s easy to eliminate it later, and it will leave you with a wonderful finished mask to show off to everybody! It’s also a good idea to wash away any excess paint after you’re done, so you don’t wind up with smudges or smears on your dog.
Then it is time to glue the mask onto your dog’s head. First you need to make sure that you have a secure fit between the mask and your dog’s head. Once you’ve made sure that it is secure, then you can begin to glue the mask onto the dog’s face. Take the piece of cardboard that’s used for the base of the mask and then fold it over. Make sure that it’s quite strong and then use your hands to ensure the cardboard down in place.
Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds until you’ve got the mask snugged securely onto the surface of your dog. Don’t make the folds too large or else it might look messy. Once you’ve completed this, you can then take out the mask and attach the cardboard ears. And attach the other area of the mask onto the dog. Be sure the ears are flat and be sure that it’s not too short or long as this can cause some problems with the mask slipping off the dog’s face.
If you are using a dog mask because your dog protection, you will need to do some sanding to be sure that it’s secure on your dog. You can accomplish this by sanding off any excess paper which might have been removed from your mask.